I need a print-ready 3D model for an outdoor information stake that I can run on my large-format printer. The finished piece stands 30" tall and holds a plaque measuring 11" wide by 8.5" high set at a fixed 45-degree viewing angle. To make printing manageable I want the stake split into two sections that push together with a clean snap-fit joint—no threads or twist locks. Both sections will be printed in PLA and I’m aiming for a glossy finish straight off the bed, so keep overhangs sensible and surfaces oriented for the smoothest result. Key points you should hit: • Geometry: 30" + 8.5" plague height overall height, plaque 11" × 8.5" on a 45° tilt. • Assembly: single, reliable snap-fit connection; tolerances suitable for PLA. • Printability: break the model into only the two requested pieces; no supports in hard-to-remove areas; fits a 400 mm build volume. • Deliverables: STL (or STEP + STL) for both sections, brief note on printer settings and any post-processing needed to achieve the glossy look. I’ll test-print as soon as I receive the files and release the milestone once the two parts are made cleanly and sit at the correct angle.