I need a pcb using an ESP32-S3-wroom1. The board will have a usb-c port for programming. The board will use a 7.2v nimh battery connected to a buck converter to power the board. Pin 21 of esp32 will be connected to a 100 ohm resistor, which is connected to a irlz44n mosfet. I have attached pictures of the breadboard I made of the circuit. Please also include all necessary peripherals so that the esp 32 can be programmed and a reset switch similar to the dev board in the pictures. I will require a PCB design with all of the components and BOM with readily available parts.