I need a production-ready SolidWorks model of a hollow spray bottle based on a single reference photo. The final part must hold exactly 118 ml, use a standard 24-410 neck finish, and be built for blow-molding in plastic with a smooth exterior surface. Key points you must hit: • Wall thickness set for typical HDPE/PET blow-molding throughout (consistent and uniform, no paper-thin spots). • The model must be fully parametric so I can tweak height or diameter later without breaking the neck thread or volume. • Internal volume verified in SolidWorks at 118 ± 0.5 ml with the cap off. • No logos, embossing, or label panels—keep the body completely blank and clean. • Deliver the native .SLDPRT file plus STEP/IGES export and a quick PDF drawing showing main dimensions and calculated volume. I’ll send the photo reference the moment we start. Please return first screenshots for confirmation within 24 hours and final files inside 48 hours total. I’m available for rapid feedback during the build, and I’ll release approval as soon as the volume check, neck spec, and wall-thickness callout all look good.