I need a detailed digital mock-up that brings my new single-band, casual-wear slider strap to life. The strap is mostly leather, with elastic texture only on the narrow wings that link the centre band to the rounded ends that slot into the sole. Shape & proportions The band is curved, following a light foot-shaped arch rather than lying flat. Overall width is about 20 cm from end to end, the centre height reaches 7 cm, and thickness should read between 8 – 10 mm. The central leather section spans roughly 14 – 15 cm and should look slightly stiff with a perfectly smooth surface so my artwork can sit cleanly on it later. Either side, 2.5 – 3 cm elastic “wings” taper down to the rounded, firm-looking ends that tuck into the sole. Visual expectations Material finish must clearly read as premium leather on the main band, contrasting with a subtle elastic weave on the wings. The whole strap should convey a medium flex—comfortable yet supportive enough for everyday, laid-back use. Artwork placement I’ll supply the final design file for the centre band once the mock-up layout is approved, so please leave that zone blank and perfectly smooth in your initial render. Deliverables • High-resolution, photo-realistic renders: front, side, and ¾ perspective • Layered source file (e.g., PSD, AI, or native 3D format) with editable textures and colours • Separate material maps or texture layers for leather and elastic surfaces Acceptance The geometry must match the dimensions above within 1 mm tolerance, clearly distinguish leather from elastic, and be supplied in a file I can reopen and adjust.