I’m trying to program a Texas Instruments C2000 board in Uniflash, but the process stops each time with an “unknown error code” during flashing. Connection is fine and the .out file builds correctly; the problem appears only when Uniflash writes to the device. I need someone who knows Uniflash and the C2000 family to: • Identify the root cause of the flashing failure. • Provide a clear, reproducible fix so the .out file loads and verifies successfully. • Share concise notes on the steps taken (settings adjusted, firmware-side changes, or tool versions used) so I can repeat the procedure on my end. Remote access or screen-share is available if that speeds things up. A quick turnaround is appreciated—once the board flashes without errors and I can repeat the process, the job is done.