I need a clean, print-ready 3D model of two interlocking hearts designed as a matching bride-and-groom set. Each heart will be printed separately, when completed the right(groom) will sit on top of the left (bride) neatly side by side when printed, share the same flat back, and include a recessed hole sized for a small disc magnet on the back of each heart in the center. I’ll provide a reference photo to make the concept crystal-clear. Dimensions & look (curved hearts, like the red hearts pictured but not together) • Bride heart: 2 ¼" wide × 2 ¼" tall(please use the flower design for dress) • Groom heart: 2 ½" wide × 2 ½" tall (please use military uniform for groom, you can remove small details for easier print) Traditional wedding attire is the theme—think dress lines, lapel, hexagonal knot and tie—rendered with moderate detail so the features stand out after FDM printing without turning fragile. This layer will sit atop the two hearts. Think stencil layer. Key requirements • Flat back on both hearts with a centered magnet cavity (I’ll confirm magnet diameter once we start). • The two fronts must align flush when placed shoulder-to-shoulder. • Optimised wall thickness and support angles for standard 0.4 mm nozzle printing. • Deliverables: final STL (and original source file from Blender, Fusion 360, SolidWorks or similar), plus a quick render so I can visualise before printing. I’ll run a test print immediately, so please be prepared for one round of adjustment if any tolerances are off. Looking forward to seeing your creativity on these wedding keepsakes.